SensoNODE Sensors

LED Status - Start Up Sequence

Red - Green - Blue - Sensor start up (If this repeats over and over, the battery is too low to start up the radio) 

LED Status - Long Fading Flash

Red - Sensor is in Discovery Mode. Looking to connect with a receiver. (Sensor will attempt to connect every 3 seconds. If it is unable to join after 200 attempts it will go into a deep sleep state) 

LED Status - Single Brief Flash 

The LED gives a different color depending on the data measured. It is broken into 4 quartiles

Green - Sensor Measurement - Sensor reading between 0% - 25% of span

Yellow - Sensor Measurement - Sensor reading between 25% - 50% of span

Orange - Sensor Measurement - Sensor reading between 50% - 75% of span

Red - Sensor Measurement - Sensor reading between 75% - 100% of span

Examples: 

Humidity sensor measures 0%-100%

Green - 0% - 25% 

Yellow - 25% - 50% 

Orange - 50% - 75% 

Red - 75% - 100% 

Temperature sensor measures (-40°F) - 230°F

Green: (-40°F) - 27.5°F 

Yellow:  27.5°F - 95°F

Orange: 95°F - 162.5°F

Red : 162.5°F - 230°F

Vibration sensor measures X-axis peak acceleration 0 milli-g - 532+milli-g

Green: 0 milli-g - 176 milli-g

Yellow:  177 milli-g - 354 milli-g

Orange: 355 milli-g - 531 milli-g

Red : 532 milli-g - Above

PRN Receivers

• Supplies continuous power to sensors
• Used with IEC/UL 508 Class 2 power supply
  • The chargers below have been tested and found to work. Most of them are available through Amazon and elsewhere.
    • mfgr: LG     model MCS-01WR (Google Nexus phones)
    • mfgr: Motorola   model SPN5504A (Droid phones), and SPN5505A (Motorola phones)
    • mfgr: Samsung  model ETA0U80JBE (Samsung phones)
    • mfgr: Samsung  model EP-TA10JWE (Samsung galaxy tablets)
    • mfgr: Asus  model AD83531 (google nexus tablets)
  • USB adapters have also been tested and found to work with the non-compliant USB chargers.  PortaPow USB adapters universal version only has been found to work.  The smart charge or Apple versions did not work.

LED Status - Start Up Sequence

Red - Green - Blue - Sensor start up

LED Status - Working as Repeater

Blue: Every 2 seconds

LED Status - Working as a PRN (Every 2 Seconds)

Green: It has received a transmission from one or more linked Sensor Nodes

Blue: It has not received a transmission from Sensor Nodes since previous LED blink. 

Red - Green (Continuously): Cannot initialize the wireless communications stack and initialize the radio.