SensoNODE Silver - Power Cycle

How do I power cycle a SensoNODE Silver sensor / transmitter?

Open

Figure 1

STEP 1: Orient the sensor so you are looking at the rear of the sensor / transmitter

STEP 2: Locate the two Torx-15 screws (as shown in Figure 1, Part C)

STEP 3: Remove the two Torx-15 screws

STEP 4: Remove the battery cover (as shown in Figure 1, Part A)

Open

Figure 2

STEP 5: Locate the ON/OFF switch (as shown in Figure 2)

STEP 6: Slide the switch to the left, putting the switch in the OFF position (as shown in Figure 3)

STEP 7: Wait 5 seconds

STEP 8: Slide the switch to the right, putting the switch in the ON position

STEP 9: Reposition the battery cover on the sensor / transmitter body

STEP 10: Reinstall the two Torx-15 screws