How do I setup my gateway?
Answer
What comes in the box
- 1- Vantron Gateway
- 1- Power Cord
- 2- 3G/4G Primary and Secondary
- 2- BT/WLAN
- 1- RF
- 1- GPIO/CAN
How to Set Up the Gateway
If the system is running normal Voice of the Machine Edge, it can be discovered using TUI (Terminal User Interface) access.
- Connect a monitor to the gateway (VGA Cable not included)
2. Connect to a network. (Always ETH1)
Make sure the network is not behind a company firewall as this will not assign an IP address to the device.
3. Connect all antennas
5. The gateway should look like the picture below after you complete steps 1-3
6. Connect the power cable. (Flat side to the ground)
7. The gateway will power on and you should hear a long beep. On the screen you will see the TUI and it will display the IP address the gateway was assigned too. (The first line of URL)
8. Once the IP address is obtained, navigate to it in order to get started with Voice of the Machine Edge
